Friday, April 26, 2024

Recruitment Not Found

You did not come from a valid link as there is no recruitment number associated with this page request.

Introduction

banner

In Cooperation With

YTC

is assisting with the recruitment and on-the-job training for

Supermetal

Valmet

The Lancaster, SC Valmet Service Center (formerly Metso) is expanding their state-of-the-art manufacturing facility with capabilities of fabricating most pressure boiler parts.

Potential employment opportunities exist for:

Welder/Fabricator

Employee will be responsible for layout, fit, and fabrication of metal components to assemble structural forms, using knowledge of welding techniques, metallurgy, and engineering requirements. Employee will also analyze engineering drawings and specifications to plan welding operations where procedural information in unavailable. For additional information, please visit www.valmetpowerservicena.com

Preferred Qualifications:

High school diploma or equivalent.
Must have knowledge of machines and tools, including their design, use, repair, and maintenance; knowledge of design techniques and principals involved in production of blue prints, drawings, and models.
Must also have knowledge of raw materials, production processes, quality control, costs, and other techniques for maximizing the effective manufacture and distribution of goods.
Ability to read and understand shop drawings and welding details, set up and adjust welding equipment to fabricate assemblies within tolerances required.
A practical skills test is required prior to hire. One or more tests may be required for hire. All tests must be completed prior to permanent position.
Must have experience in sheet metal fabrication.
Must be able to combine standing and walking 70 – 100% during a shift; lift up to 50 pounds frequently and up to 70 pounds occasionally. Requirements include bending frequently, squatting, kneeling, climbing/balancing, reaching above shoulder level and lifting from high/low positions occasionally; bending and push/pull frequently. Repetitive use of hands would be for simple grasping, pushing and pulling approximately up to 26 pounds of pressure, and fine manipulation.
Must be able to work in varying climates, indoors and outdoors including extreme heat, cold and be exposed to the natural elements.
Must be willing and able to work different shifts/days as required to meet production goals. This may include weekend work and also extended periods of overtime.

Job Duties:

Lay out, position, and secures parts and assemblies according to specifications, using straightedge, combination square, calipers, and ruler.
Tack-welds or welds Aluminum, Stainless or Carbon Steel parts in accordance with applicable Codes Section IX and/or AWS using electric, gas, arc, or other welding equipment.
Cuts work piece, using power saws, hand shears, or chipping knife.
Observes tests on welded surfaces, such as hydrostatic and dimension tolerance to evaluate weld quality and conformance to specifications.
Inspects grooves, angles, or gap allowances, using micrometer, caliper, and precision measuring instruments.
Removes rough spots from work piece, using portable grinder, hand file, or scraper.
Welds components in flat, vertical, or overhead positions.
Heats, forms, and dresses metal parts, using hand tools, torch, or arc welding equipment.
Performs routine maintenance on equipment and determines what kind of maintenance is needed.
Set up and operate plasma cutters, shears, press brakes and other metal forming tools without instruction.
Able to utilize mathematics to solve problems.
Other duties as determined by manager

Computers are available at your local SCWorks office if needed

An Equal Opportunity Employer

Recruitment Not Found

Introduction

Connect